Hustler Turf Z XR7 - Manual (Page 25)

1065674/07 4-11
Pump Belt and Pulleys Installation
NOTES:
1. Torque to 45-48 ft-lbs.
2. Torque to 12-15 ft-lbs.
3. Apply grease at zerk (see owner’s manual).
4. Included with Honda 24 HP engine (785014).
5. Electric clutch burnishing procedure: After installing a new clutch it is
important to burnish the clutch to insure maximum deck clutch life. In an
open area with no bystanders set the engine speed to half throttle. Cycle
the deck clutch on for 15 seconds, and then off for 15 seconds. Repeat
this operation 10 times, it will require about 5 minutes to complete.
INDEX
NO.
SERVICE
PART NO.
MFG.
PART NO.
QTY DESCRIPTION
1 779876 779876 1 ENGINE SC SINGLE PULLEY
2 212076 212076 1 KEY 1/4 SQ X 1.50 LONG
3 787366 787366 1 WARNER CLUTCH
4 783829 783829 1 FW .460 X 1.750 X .250 ZNYC
5 785659 785659 1 CS .437-20 X 2.50 HX G5 ZNYC
6 083196 083196 4 SS .312-18 X .750 SQ-HD ZN
7 768127 768127 2 KEY 5MM X 30MM RADIUS ENDS
8 325308 325308 2 PULLEY & FAN
9 008193 008193 2 NT .500-13 HX G5 ZNYC
10 767962 767962 4 FW .531 X 1.063 X .090 SAE HD ZN
11 016527 016527 2 CS .500-13 X 1.00 HX G5 ZNYC
12 366765 366765 1 CLUTCH ANCHOR ANGLE
13 784918 784918 2 RUBBER BUMPER
14 349761 349761 1 PUMP IDLER ARM
15 015495 015495 1 STRAIGHT GREASE FITTING
16 025296 025296 1 FW .760 X 1.625 X .08 ZN
17 061101 061101 1 NT .750-10 HX NL ZN
18 781856 781856 1 IDLER PULLEY
19 028118 028118 1 FW .62 X 1.00 X.134 ZN
20 794446 794446 1 CS .625-11 X 1.50 HX G5 ZN
21 781302 781302 1 IDLER SPRING
22 781443 781443 1 A-SEC PUMP IDLER BELT
23 791251 791251 1 HARNESS, CLUTCH PIGTAIL(DIODE)
24 036236 036236 1 CS .312-18X1.000 HX G5 ZNYC
25 768523 768523 1 FW .343 X .687 X .051/.080 HD ZNYC
26 034272 034272 1 NT .312-18 HX G5 ZNYC