Hypertec PC Card 10/100 TX - Manual (Page 4)

Static Electricity Warning
Static electricity is accumulated naturally in the human body, and can be
discharged through electrical components by touching them. This shock can
potentially cause permanent internal damage to the component.
When installing the adapter, please observe the following precautions:
Discharge yourself before commencing by touching a grounded metal appliance,
such as the metal frame of a computer - while it is tuned off, but still plugged into
the wall socket.
Hold the adapter or any other boards by their edges only. Never touch any
exposed pins on the adapter.
If possible, install the adapter as soon as you remove it from its anti-static bag,
without putting it down. If you must put it down, place it on the anti-static bag in
which it was packed.
Do not place the adapter on any metal surface.
Hardware Installation
The HyperNet PC Card 10/100 TX hardware installation is a three step process:
1. Insert the HyperNet adapter into the computers PCMCIA slot
2. Connect the media coupler to the HyperNet adapter
3. Attach the network cable
The HyperNet PC Card 10/100 TX adapter is a Type 11 PC Card with a 68-pin
connector, which is compatible with any Type 11 PCMCIA slot. If your computer
has more than one slot, you may insert the adapter in any of them. The software
will automatically determine into which slot the adapter is inserted. Gently insert
the card into the PCMCIA slot, pushing until it sits firmly in place, care must be
taken not to force it as the adapter is 'keyed' to fit only one way. If it does not
register smoothly, withdraw it and check that the keyed plug on the adapter is
correctly aligned with the keyed socket in the host PC.