Service and adjustments – Husqvarna 700DRT User Manual

Page 16

Advertising
background image

16

SERVICE AND ADJUSTMENTS

CABLE CLIP
SCREW

DRIVE
CONTROL
CABLE

EXTENSION
SPRING

ENGINE
PULLEY

IDLER
PULLEY

TRANSMIS SION
PULLEY

LESS
TENSION

5/8"

MORE
TENSION

FIG. 26

TO REPLACE GROUND DRIVE BELT
(See Figs. 25 and 26)

•

Remove belt guard as described in “TO REMOVE BELT
GUARD”.

•

Remove old belt by slipping off engine pulley first then
remove from transmission pulley.

•

Place new belt in groove of transmission pulley and
into engine pulley. BELT MUST BE IN GROOVE ON
TOP OF IDLER PULLEY. NOTE POSITION OF BELT
TO GUIDES.

•

Check belt adjustment as described below.

•

Replace belt guard.

•

Reposition wheel and replace clevis pin and hairpin
clip.

GROUND DRIVE BELT ADJUSTMENT
(See Fig. 26)

For proper belt tension, the extension spring should have
about 5/8 inch (16 mm) stretch when drive control bar is
in “EN GAGED” position. This tension can be attained as
follows:
•

Loosen cable clip screw securing the drive control
cable.

•

Slide cable forward for less tension and rearward for
more tension until about 5/8 inch (16 mm) stretch is
obtained while the drive control bar is engaged.

•

Tighten cable clip screw securely.

Advertising