Service and adjustments, Engine – Husqvarna 700DRT User Manual

Page 18

Advertising
background image

18

SERVICE AND ADJUSTMENTS

FIG. 30

engine_art_78

THROTTLE CONTROL

CLAMP SCREW

CASING
AND WIRE

ENGINE

TO ADJUST THROTTLE CONTROL CABLE
(See Fig. 30)

The throttle control has been preset at the factory and
adjustment should not be necessary. If adjustment is
necessary, proceed as follows:

With engine not running, move remote throttle control
lever to “FAST” position.

If throttle lever on engine touches high speed stop, no
further adjustment is necessary. If throttle lever does
not touch high speed stop, continue with adjustment
procedure.

Loosen cable clamp screw.

Move throttle lever up until it touches high speed stop,
and hold in this position.

Tighten cable clamp screw securely.

TO AD JUST CARBURETOR

The carburetor has been preset at the factory and ad justment
should not be necessary. However, engine per formance
can be affected by dif ferences in fuel, tem perature, al titude
or load. If the carburetor does need ad justment, contact
your nearest authorized service center/de partment

IMPORTANT: NEVER TAMPER WITH THE ENGINE GOVERNOR,
WHICH IS FACTORY SET FOR PROPER ENGINE SPEED.
OVERSPEEDING THE ENGINE ABOVE THE FACTORY HIGH
SPEED SETTING CAN BE DANGEROUS. IF YOU THINK THE
ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING,
CONTACT YOUR NEAREST AUTHORIZED SERVICE CENTER/
DEPARTMENT, WHICH HAS THE PROPER EQUIP MENT AND
EXPERIENCE TO MAKE ANY NEC ES SARY ADJUSTMENTS.

Advertising