HP XP12000 - Manual (Page 49)

Installation 51
Mounting and verifying the file systems
After the mount directories have been created, mount and verify the file
system for each logical volume.
To mount and verify the file systems:
1. Use mount to mount the file system for the volume.
Example # mount /dev/vg06/lvol1 /AHPMD-LU00
2. Repeat step 1 for each logical volume on the disk array.
If you need to unmount a file system, use the unmount command.
3. Use the bdf command to verify that the file systems are correct. The
capacity is listed under Kbytes.
Example # bdf
Filesystem Kbytes used avail %used Mounted on
/ldev/vg00/lvol1 59797 59364 0 100% /
:
/ldev/vg06/lvol1 2348177 9 2113350 0% /AHPMD-LU00
4. As a final verification, perform some basic UNIX operations (for
example file creation, copying, and deletion) on each logical device to
make sure that the devices on the disk array are fully operational.
Example #cd /AHPMD-LU00
#cp /bin/vi /AHPMD-LU00/vi.back1
#ls -l
drwxr-xr-t 2 root root 8192 Mar 15
11:35 lost+found
-rwxr-xr-x 1 root sys 217088 Mar 15
11:41 vi.back1
#cp vi.back1 vi.back2
#ls -l