Hoover Compact Canister Cleaner - Manual (Page 6)

What bags to buy
Use Hoover bag Type R with this
cleaner.
To assure that your HOOVER clean-
er operates at peak performance, it
is imperative that you use only gen-
uine HOOVER filter bags distributed
by The Hoover Company. HOOVER
bags can be identified by the trade-
marks -
Changing filter bag
Disconnect cleaner from electrical
outlet.
The bag is located behind the bag
door at front of cleaner.
Depress bag door latch to open
door; remove door.
Grasp collar to remove used bag.
®
3-1
3-3 3-4 3-5
3-6
Open pleats of new bag.
Fold edge of bag over collar, as
shown, and hold in place while posi-
tioning collar onto dirt tube. Press firmly along dotted lines until
collar is seated against five ribs (A)
(in Fig. 3-3) on door.
A
Place bottom of bag door into slot
on cleaner. Close door.
Secondary filter
Disconnect cleaner from electrical
outlet.
The secondary filter protects the
motor from dirt particles. It is located
on the back wall behind the bag.
When bag is removed, check the filter
(it is not removable). Loosen dirt
with a small brush and wipe off dirt
particles with a slightly damp cloth.
Dry thoroughly.
Rug/floor nozzle
To maintain cleaning effectiveness
of your rug and floor nozzle, the
brushes may need to be replaced
occasionally.
See your nearest Hoover Factory
Service Center or Authorized
Warranty Dealer (Depot) for new
brushes.
Lubrication
The motor is equipped with two
bearings that contain sufficient lubri-
cation for the life of the motor. The
addition of lubricant could cause
damage.
Therefore, do not add
lubricant to either motor bearing.
6
3-2