Mounting – Honeywell W8600F User Manual
Page 2
W8600F AIR CLEANER MONITOR
69-1200—2
2
Fig. 2. W8600F mounting locations.
Mounting
The following mounting instructions assume that the
W8600F is mounted next to a T8600 Thermostat. If
installing the monitor at another location, modify the
procedure to fit the installation.
1.
Hold the mounting template (included in the
W8600F kit) next to the T8600 as shown in Fig. 3.
2.
Mark the holes for the screw anchors and the
3-conductor thermostat cable.
3.
Remove the template and drill the holes.
4.
Remove the W8600F from the base.
5.
Position the W8600F base over the holes and
install the anchors and screws (included in the bag
assembly). Tighten the screws until the base is
mounted firmly on the wall.
Fig. 3. Positioning mounting template.
W8600F
W8600F
W8600F
W8600F
W8600F
EAC
EAC
EAC
EAC
EAC
M11966
RETURN AIR DUCT
CEMENT BLOCK WALL
F52-ATTIC
CLOSET
GARAGE/DRYWALL
On
Battery
Service
Fault
Air Cleaner Monitor
M11971
THERMOSTAT
WALLPLATE
MOUNTING
TEMPLATE
MOUNTING HOLES (2)
WIRING HOLE
69-1200-2.fm Page 2 Tuesday, December 3, 2002 11:21 AM