Heat & Glo Fireplace 6100PLUS - Manual (Page 21)

Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05 21
A. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
Shock Risk
Fire Risk
Use ONLY optional accessories approved
for this appliance.
• Using non-listed accessories voids
warranty.
• Using non-listed accessories may result
in a safety hazard.
• Only Hearth & Home Technologies
approved accessories may be used
safely.
WARNING
Explosion Risk
• Follow rockwool placement instructions
in this manual.
• Do NOT place rockwool directly over
burner ports.
• Replace rockwool material annually.
Improperly placed rockwool interferes with
proper burner operation.
WARNING
10 10
Appliance Setup
• The appliance is shipped with the burner in place with the
boxed up log set sitting on it. See Figure 10.1. Remove
box.
• The refractory is not shipped with the appliance. The
refractory must be ordered separately. Install the refractory
following the installation instructions supplied with the
kit.
• The grate is shipped on top of the appliance. See
Figure 10.2. Remove the grate.
Figure 10.1 /Boxed Logs
Figure 10.2 Shipping Location of Grate
B. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated in-
side the fi rebox or underneath in the control cavity.
C. Lava Rock, Rockwool, Silica Rock Placement
Placing the Lava Rock
• Place the lava rock generously around the ember bed and
up to the front lip of the hearth pan. You do not need ot
use the whole bag; save the remaining amount for future
use.
Figure 10.3 Placing the Lava Rock