Horizon Fitness ELITE SERIES 4.2T - Manual (Page 4)

BEFORE
YOU
BEGIN
6
INTRODUCTION
ASSEMBL
Y
BEFORE
YOU
BEGIN
TREADMILL OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
ASSEMBL
Y
IMPORT
ANT
PRECAUTIONS
BEFORE YOU
BEGIN
ASSEMBL
Y
7
INTRODUCTION
TREADMILL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
IMPORT
ANT
PRECAUTIONS
IMPORTANT: READ THESE SAFETY INSTRUCTIONS BEFORE USE!
UNPACKING
Place the treadmill carton on a level flat surface. It is recommended that you place a protective covering on
your floor. Take CAUTION when handling and transporting this unit. Never open box when it is on its side. Once
the banding straps have been removed, do not lift or transport this unit unless it is fully assembled and in the
upright folded position, with the lock latch secure. Unpack the unit where it will be used. The enclosed treadmill
is equipped with high-pressure shocks and may spring open if mishandled. Never grab hold of any portion of
the incline frame and attempt to lift or move the treadmill. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD
RESULT IN INJURY!
Before proceeding, find your treadmill’s serial number and model name located to the left of the on/off power
switch and power cord and enter it in the space provided below.
ENTER YOUR SERIAL NUMBER AND
MODEL NAME IN THE BOXES BELOW:
SERIAL NUMBER:
MODEL NAME:
* Refer to the SERIAL NUMBER and MODEL NAME when calling for service.
* Also enter this serial number on your Warranty Card.
WARRANTY REGISTRATION
Your warranty card must be completed and sent to Horizon Fitness within thirty days of purchase or registered
online at www.horizonfitness.com, before a warranty claim can be processed. Please keep your receipt with
the user’s guide as it may be required for a warranty claim. Make sure to send in your warranty registration
card to validate your warranty.
WARNING WARNING
During the assembly process of the treadmill there are several areas that special
attention must be paid. It is very important to follow the assembly instructions
correctly and to make sure all parts are firmly tightened. If the assembly
instructions are not followed correctly, the treadmill could have frame parts that
are not tightened and will seem loose and may cause irritating noises. There should be no side-to-side play in
the console masts or any forward and back play in the console assembly or handlebars. If there is any play in
these areas, the treadmill has not been properly assembled. To prevent damage to the treadmill, the assembly
instructions must be reviewed and corrective actions should be taken.
�������������
����������������������������������������������������������������������������������������������������������
��������������������������������������������������������������������������������������
�����
������������
������������
����������������������
���������������
����������������������������������������
������������������
�
����������������
����������������
������������
������������
�������������������
������������
���������������
�������
������������������
��������������������
���������������
�������������
����������
�������
���������
����������������������
�����������
���������
��������������
������������
�����������
����������������
Elite 1.2T-5.2T Rev 1.4.indd 6-7 8/2/05 2:46:56 PM