HP PROCURVE 530 - Manual (Page 50)

3-8
Getting Started With Access Point Configuration
Ge
tti
ng S
ta
rte
d Wi
th
Ac
cess
Po
int
Con
fig
ura
tio
n
Here is some information on the basic IP address and wireless configuration
parameters. For more information on these parameters, see the Management
and Configuration Guide
.
Parameter Default
Username admin The name of the manager.
Password admin The password for the manager.
IP Address 192.168.1.10 IP address compatible with your network.
Subnet Mask 255.255.255.0 Subnet mask compatible with your network.
Default Gateway not set IP address of the next-hop gateway node for network traffic that needs to
be able to reach off-subnet destinations.
Radio 1 Mode 802.11g The operating mode for Radio 1.
Radio 2 Mode 802.11a The operating mode for Radio 2.
SSID Radio 1 - SSID 1
Radio 2 - SSID 2 The Service Set Identifier (SSID) for the access point interface, which is
broadcast in the beacon frames.
Channel Policy Auto The radio channel through which an access point radio communicates
with its wireless stations. When attempting to connect, most wireless
stations automatically set their radio channel to the same channel used
by the access point.
Wireless Operation Enabled Wireless operation is automatically enabled after you have set the country
code.
Note: The IP address and subnet mask assigned for the access point must be compatible with the IP addressing used
in your network. For more information on IP addressing, see the Management and Configuration Guide.