HP 39g+ - Manual (Page 203)

Notes and sketches 14-5
To label parts of a
sketch 1. Press U@YU• and type the text in the edit line. To lock the
Alpha shift on, press 6a• (for uppercase) or
>6+,)7@
6a•
(for lowercase).
To make the label a smaller character size, turn off 7DB•
before pressing 6a• . ( 7DB• is a toggle between small and
large font size). The smaller character size cannot display
lowercase letters.
2. Press PF• .
3. Position the label where you want it by pressing the
*k,,
*e,,*A,,*>, keys.
4. Press PF• again to affix the label.
5. Press 9S6X• to continue
drawing, or press
>+20(@ to exit Sketch
view.
To create a set of
sketches You can create a set of up to ten sketches. This allows for
simple animation.
• After making a sketch, press I@XQ• to add a new, blank
page. You can now make a new sketch, which becomes
part of the current set of sketches.
• To view the next sketch in an existing set, press Q6B@ɕ .
Hold Q6B@ɕ down for animation.
• To remove the current page in the current sketch series,
press
>'(/@.
To store into a
graphics variable You can define a portion of a sketch inside a box, and then
store that graphic into a graphics variable.
1. In the Sketch view, display the sketch you want to copy
(store into a variable).
2. Press TUPc• .
3. Highlight the variable name you want to use and press
PF• .
4. Draw a box around the portion you want to copy: move
the cursor to one corner, press PF• , then move the cursor
to the opposite corner and press PF• .