Husqvarna 966061401 - Manual (Page 27)

1
2
3
CONTROls
27
Refueling
Propane Model
Read the safety instructions before refueling. The
machine has two propane cylinder tanks, one on each
side. Use only propane cylinders approved for this
unit.
Regularly check the cylinders for damage and keep
the valves properly tightened.
To exchange cylinders, turn the fuel valve clockwise
to close. Remove the fuel line by turning the fitting
clockwise (Left hand fitting).
Release the toggles holding the cylinders to the
supports and lift the cylinders up off the alignment
bolt and away from the unit.
WARNING!
The engine and the exhaust system,
become very hot during operation.
Risk for burns if touched.
Allow engine and exhaust system to
cool at least two (2) minutes before
changing cylinder tanks.
WARNING!
Store propane cylinders away from
open flames or where electrical
arcing can occur. Do not tamper
with the valves and fittings on the
cylinder.
8065-008
1. Toggles
2. Fuel Valve
3. Alignment Bolt
Set tank over alignment bolt
IMPORTANT INFORMATION
Cylinders contain internal baffles and must be
oriented properly. Use the alignment bolt on
the cylinder support to seat the cylinder into
the proper position.
Reverse procedure with full cylinders and tighten fuel
line valve securely. open fuel valve for operation.
IMPORTANT INFORMATION
Propane fueled mowers draw from both tanks.
It is recommended to keep at least ½ gallon
of fuel in each tank when starting. During
operation, the mower will draw and empty
both tanks.