Cpz™ adsorbent module – Honeywell F111 Series 2 User Manual
Page 7
F111 (SERIES 1,2) IN CEILING MEDIA AIR CLEANER
7
68-0198EF-4 Rev. 11-07
IMPORTANT
Do not touch the pleated filter media. Handle only the
filter frame to prevent damage to the filter media.
7.
Close and latch the lid.
CPZ™ Adsorbent Module
The CPZ™ adsorbent module is used to collect gases,
vapors, odors and volatile organic compounds (V.O.C.) from
the air that passes through the air cleaner. Adsorbents collect
and hold 25% to 50% of their weight in odorous gases and
vapors. The impurities are collected until the adsorbents reach
saturation. At saturation, the adsorbents emit a continuous
strong pungent odor. If the air cleaner is turned off for 8 to 10
hours, there will a temporary odor when it is turned back on. If
the odor persists for 30 minutes, it is time to replace the filters.
NOTE:
When tobacco smoke is a contaminant, both the
particle filter and the adsorbent filter will need to be
serviced at the same time.
1.
Slowly open the lid, supporting the lid so the filters do
not fall out.
2.
For Series 1 only.Support the adsorbent module with
one hand and release the fastener.
3.
For Series 2 only.Support the adsorbent module with
one hand and turn open the catches
4.
Use two hands and slide the filter from the housing.
IMPORTANT
The module weighs about 26 lb (12 kg) and can be
hard to handle.
5.
Place the spent module in a plastic trash bag and
dispose of properly.
6.
Remove CPZ™ sorbent modules from their packaging
and install. Be sure the fastener tabs (3) are facing
downward and fastened.
7.
For Series 1 only. Be sure the fastener tabs are facing
downward and fasten them.
8.
For Series 2 only.Be sure both catches are turned
down and filter rests firmly on catches.
9.
Close and latch the lid.
NOTE:
On initial startup, a small amount of dust can blow
from the air cleaner. This is normal and stops a few
minutes after startup. The start-up filters will catch all
the dust. The startup-filters are placed in the two
exits outlets on the grill. After running the unit for 5
minutes, turn off the unit. Remove and discard the
two start-up filters.