Horizon Fitness CX-66 - Manual (Page 8)

BEFORE
YOU
BEGIN
14
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ELLIPTICAL OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y
15
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ELLIPTICAL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
ASSEMBLY STEP 9
LOWER HANDLEBAR
LOWER LINK ARM
INSIDE
ELBOW COVER
OUTSIDE
ELBOW COVER
SCREW (L)
CONSOLE
CONSOLE WIRES
PRE-ATTACHED
SCREWS
ASSEMBLY STEP 8
SCREWS (Q)
INSIDE ELBOW COVER
OUTSIDE ELBOW COVER
ELBOW JOINT
A) Open HARDWARE BAG FOR STEP 8.
B) Attach the OUTSIDE ELBOW COVER to the ELBOW JOINT using 1 SCREW (Q).
C) Snap the INSIDE ELBOW COVER onto the OUTSIDE ELBOW COVER.
Note the position of the snap tabs before snapping into position.
D) Attach the INSIDE ELBOW COVER to the ELBOW JOINT using 1 SCREW (Q).
E) Repeat on other side.
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
A) Attach the CONSOLE MAST wires to the CONSOLE wires .
B) Carefully tuck the CONSOLE MAST wires into the CONSOLE MAST before attaching the CONSOLE.
C) Attach CONSOLE to the CONSOLE MAST using the 4 PRE-ATTACHED SCREWS (screws will have to be removed
from the console first).
DO NOT PINCH WIRES!
Connect AC ADAPTOR to the AC ADAPTOR INPUT, located at front of the main frame. Connect
ADAPTOR to a power outlet. Locate the ON / OFF switch on the back of the CONSOLE. Flip the switch
to the ON position. After a “beep”, the CONSOLE will turn on.
HARDWARE BAG FOR STEP 8 CONTENTS :
SCREW (Q)
15 mm
Qty: 4
YOU’RE FINISHED!
CX-66_Elliptical_Rev.1.6.indd 14-15 6/13/07 1:26:49 PM