Attaching the tiller to the tarctor, Tiller to the tractor, Attaching the tiller to the tractor – HONDA TL5040 User Manual

Page 12

Advertising
background image

ATTACHING THE TILLER TO
THE TRACTOR

Ensure the tractor has been

prepared as instructed under TRACTOR
PREPARATION section

of

this manual to

prevent serious personal injury

or

equipment

damage.

4

Attach the lower lift

arms

of the three point

hitch and secure with clips as shown Fig. 15.

Install the hitch top link to the tractor
mounting bracket and secure with clip as
shown Fig. 13.

Install

the other end of the hitch top link to the

tiller and secure with clip as shown Fig. 17.

(note: the top link should be installed with the
locking

nut

towards the tiller).

Adjust the right hand hitch lift

make the

tiller parallel with the ground (left to right)
when the tiller is raised slightly off the
ground. Shortening the lift rod will raise the
right side of the tiller, lengthening the lift rod
will lower the right side of the tiller Fig. 12.

Adjust the hitch top link to make tiller parallel
with the ground (front to rear).
Increasing the length of the top link will cause
the rear of the tiller to drop, shortening the
link will cause the rear of the tiller to raise.
Tighten

the

nut on the top link

securely Fig. 17.

hair pin

tiller A-lrame

I

6

Position the tiller to sit approximately in the
center of the rear wheels and adjust the
stabilizer check links to prevent excessive left
to right sway Fig.

16.

7 Attach the tiller driveline to the tractor

by: Fig. 14-18

-

Fully depressing the

collar and slowly

push on the driveline until the locking collar
returns to the locked position.

-

Move the driveline back and forth

to

ensure it is

securely connected.

-

Make certain the driveline shields are in place

Do

not operate the tiller without the driveline

shields in place and in good condition. This could
result in severe personal injury or death.

When attaching the

PTO

driveline to the tractor,.

it is important that the

PTO

collar be

locked in the groove

on

the end of the driveline.

Before operating tiller, raise and lower the tiller
slowly through its full range with the three point
hitch to ensure the driveline does not bottom out

and are in good condition.

hitch brackets

Advertising