Hobart Welding Products HOOD XVX - Manual (Page 10)

OM-240 362 Page 8
SECTION 5 − REPLACING THE LENS COVERS
5-1. Replacing Outside Lens Cover
!
Never use the auto-darkening
lens without the inside and
outside lens covers properly
installed. Welding spatter will
damage the auto-darkening
lens and void the warranty.
1 Front Lens Holder
2 Release Points
3 Lens Cover
4 Gasket
Remove front lens holder by press-
ing release points and pulling the
holder away from the helmet.
Remove lens cover and gasket from
the holder. Replace lens cover and
reinstall gasket and lens in holder.
Reinstall holder in helmet.
.
Be sure the flat side of lens
cover gasket faces the lens cov-
er holder.
8804 814 / 804 816
1 2
Be sure flat side of gasket
faces lens cover holder.
2
4
3