Horizon Fitness WT951 - Manual (Page 6)

INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE YOU
BEGIN
TREADMILL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
TREADMILL OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
ASSEMBLY STEP 
YOU’RE FINISHED!
ASSEMBLY STEP 
A Open HARDWARE BAG .
B Slide HANDLEBARS onto
CONSOLE.
C Attach HANDLEBARS to
CONSOLE using 4 BOLTS (K)
and 4 ARC WASHERS (L).
D Connect power plug to the
treadmill and connect the cord to
a power outlet. The on/off switch
is located next to the power
cord. Flip this switch to the ‘on’
position, so that the switch is
lit. You will hear a beep and the
console will light up.
108&3
48*5$)
$*3$6*5
#3&",&3
BOLT (E)
15 mm
Qty: 4
BOLT (J)
38 mm
Qty: 2
FLAT WASHER (G)
12 mm
Qty: 4
SLEEVE (I)
26.5 mm
Qty: 2
SPRING WASHER (F)
10 mm
Qty: 4
SCREW (H)
12 mm
Qty: 5
HARDWARE BAG  CONTENTS :
$0/40-&
."45
#0-5
&
413*/(
8"4)&3
'
'-"5
8"4)&3
(
$3044
#"3
STEPS A-C
4$3&84
)
#0-5
+
4-&&7&
*
4503"(&
3"$,
$0/40-&
."45
$3044
#"3
STEPS D-G
#0-5
,

NN
2UZ

BOHMF
WJFX
"3$
8"4)&3
-
2UZ

HARDWARE BAG  CONTENTS :
"3$
8"4)&3
-
#0-5
,
)"/%-&#"3
$0/40-& A Open HARDWARE BAG .
B Align CROSS BAR with holes in
CONSOLE MAST.
C Insert 1 BOLT (E), 1 SPRING
WASHER (F) and 1 WASHER
(G) into the bottom holes of
the CROSS BAR.
NOTE: Do not insert the top
bolts until Step 3-F, after
the STORAGE RACK has been
attached.
D Attach 2 SLEEVES (I) to BOLTS
(J). Insert 2 BOLTS (J) into
CONSOLE MASTS.
E Slide STORAGE RACK over
SUPPORT BAR and snap
bottom of STORAGE RACK to
BOLTS (J).
F Now you may insert the top 2
BOLTS (E) into the SUPPORT
BAR. Tighten all 4 BOLTS (E).
G Attach STORAGE RACK to
CROSS BAR using 5 SCREWS
(H).
10 11
WT951_Pedo_Treadmill_Rev.1.3.ind10-11 10-11 9/15/06 1:03:00 PM