HP f2304 - Manual (Page 51)

Agency Regulatory Notices
User’s Guide B–5
Power Cord Set Requirements
The monitor power supply is provided with Automatic Line
Switching (ALS). This feature allows the monitor to operate
on input voltages between 100-120V or 200-240V .
The power cord set (flexible cord or wall plug) received with
the monitor meets the requirements for use in the country
where you purchased the equipment.
If you need to obtain a power cord for a different country,
you should purchase a power cord that is approved for use
in that country.
The power cord must be rated for the product and for the
voltage and current marked on the product’s electrical
ratings label. The voltage and current rating of the cord
should be greater than the voltage and current rating
marked on the product. In addition, the cross-sectional area
of the wire must be a minimum of 0.75 mm² or 18AWG,
and the length of the cord must be between 6 feet (1.8 m)
and 12 feet (3.6 m). If you have questions about the type of
power cord to use, contact your HP authorized service
provider.
A power cord should be routed so that it is not likely to be
walked on or pinched by items placed upon it or against it.
Particular attention should be paid to the plug, electrical
outlet, and the point where the cord exits from the product.