Transmission fluid – HONDA 31SAA610 User Manual
Page 199
Check the fluid level with the engine
at normal operating temperature.
Park the vehicle on level ground.
Start the engine, let it run until the
radiator fan comes on, then shut
off the engine. For accurate
results, wait about 60 seconds (but
no longer than 90 seconds) before
doing step 2.
Remove the dipstick, and check
the fluid level. It should be
between the upper and lower
marks.
If the level is below the lower
mark, add fluid into the dipstick
hole to bring it to the level
between the upper and lower
marks.
Pour the fluid slowly and carefully so
you do not spill any. Clean up any
spill immediately; it could damage
components in the engine
compartment.
Always use Honda ATF-Z1
(automatic transmission fluid).
Insert the dipstick all the way into
the transmission securely as
shown in the illustration.
Remove the dipstick (yellow loop)
from the transmission, and wipe it
with a clean cloth.
1.
2.
3.
5.
4.
CONTINUED
Transmission Fluid
Automatic Transmission Fluid
Ma
int
e
na
nce
193
DIPSTICK
UPPER
MARK
LOWER
MARK
HOT
MARK