HONDA 31SAA610 - Manual (Page 207)

Open the tailgate. Place a cloth on
the edge of the light assembly
cover. Remove the cover by
carefully prying in the notch on its
middle edge with a flat-tip
screwdriver. Determine which of the four bulbs
is burned out: stop/taillight, back-
up light, turn signal light, or
taillight.
Remove the socket by turning it
one-quarter turn counterclockwise.
Remove the burned out bulb from
the socket by pulling it straight out
of its socket.
Install the new bulb in the socket.
Turn on the lights to make sure
the new bulb is working.
Reinstall the socket into the light
assembly by turning it clockwise
until it locks.
Reinstall the light assembly cover.
1. 2.
3.
4.
5.
6.
7.
8.
Replacing Rear Bulbs
Lights
Ma
int
e
na
nce
201
LIGHT ASSEMBLY COVER