HP 250C - Manual (Page 100)

6Ć42 Removal and Replacement C4699Ć90000
10 Use the right cam journal to raise the
pinchĆwheels, and lift the right side of the
drive roller up.
11 Lift the roller out of the plotter.
W A R N I N G
Reassembling: See following procedure.
After reassembling, make sure that you
check the carriageĆtoĆmedia distance '
page 7Ć11
Reinstalling the Drive Roller
W A R N I N G
In the following procedure, take care
not to injure your fingers if you let the
drive roller snap into place.
C A U T I O N
Inthe following procedure
D Take care not to damage the media
separator. Don't let it slip under the drive
roller.
D Take care that the edge of the media
separator does not damage the rubber
surface of the drive roller.
1 Flex the media separator upwards and
position the roller behind it and on top of
the pinch wheels.
2 Make sure that the gear onthe left side of
the roller is positioned immediately to the
left of the sideĆplate.