Service and adjustments – Husqvarna 600CRT User Manual

Page 15

Advertising
background image

SERVICE AND ADJUSTMENTS

15

FIG. 22

CAP NUT
AND
WASHER

TO REMOVE BELT GUARD (See Fig. 22)

Remove L.H. outer and inner side shields (See “TO
REMOVE WHEEL” in this section of this manaul).

Remove hairpin clip and clevis pin from left wheel. Pull
wheel out from tiller about 1 inch.

Remove two (2) cap nuts and washers from side of belt
guard.

Remove hex nut and washer from bottom of belt guard
(located behind wheel).

Pull belt guard out and away from unit.

Replace belt guard by reversing above procedure.

HEX NUT
AND
WASHER
(LOCATED
BEHIND
TIRE)

BELT GUARD

CAP NUT
AND WASHER

HAIRPIN CLIP AND
CLEVIS PIN

BELT
GUIDE “B”

BELT
GUIDE “A”

CABLE CLIP
SCREW

DRIVE
CONTROL
CABLE

EXTENSION
SPRING

STUD “C”

ENGINE
PULLEY

IDLER
PULLEY

TRANSMISSION
PULLEY

LESS
TENSION

5/8"

MORE
TENSION

TO REPLACE GROUND DRIVE BELT (See
Fig. 23)

Remove belt guard (See “TO REMOVE BELT GUARD”
in this section of this manual).

Loosen belt guides “A” and “B” and also stud “C”.

Remove old belt by slipping off engine pulley first then
remove from transmission pulley.

Place new belt in groove of transmission pulley and
into engine pulley. BELT MUST BE IN GROOVE ON
TOP OF IDLER PULLEY. NOTE POSITION OF BELT
TO GUIDES.

Tighten belt guides “A” and “B” and stud “C.

Check belt adjustment as described below.

Replace belt guard.

Reposition wheel and replace clevis pin and hairpin
clip.

Replace inner and outer side shields.

GROUND DRIVE BELT ADJUSTMENT (See
Fig. 23)

For proper belt tension, the extension spring should have
about 5/8 inch stretch when drive control bar is in “EN-
GAGED” position. This tension can be attained as follows:

Loosen cable clip screw securing the drive control
cable.

Slide cable forward for less tension and rearward for
more tension until about 5/8 inch stretch is obtained
while the drive control bar is engaged.

Tighten cable clip screw securely.

FIG. 23

Advertising