Husqvarna 600CRT - Manual (Page 16)

SERVICE AND ADJUSTMENTS
16
FIG. 26
TINE REPLACEMENT (See Figs. 24, 25, and 26)
CAUTION: Tines are sharp. Wear
gloves or other protection when han-
dling tines.
A badly worn tine causes your tiller to work harder and dig
more shallow. Most important, worn tines cannot chop and
shred organic matter as effectively nor bury it as deeply as
good tines. A tine this worn needs to be replaced.
FIG. 25
• To maintain the superb tilling performance of this
machine the tines should be checked for sharpness,
wear, and bending, particularly the tines which are next
to the transmission. If the gap between the tines
exceeds 3-1/2 inches (9 cm), they should be replaced
or straightened as necessary.
• New tines should be assembled as shown in Fig. 26.
Sharpened tine edges will rotate rearward from above.
TINE TINE
3-1/2" MAX
(9 CM)
SHARP EDGE
HAIRPIN CLIP
SHARP
EDGES
COUNTER
TINE
ROTATION
SHARP EDGES
SHARP EDGE
SHEAR PIN
SHEAR PIN
HAIRPIN CLIP
FIG. 24
NEW TINE WORN TINE