Harbor Freight Tools 67854 - Manual (Page 9)

Page 9 For technical questions, please call 1-800-444-3353. Item 67854
91214
LENS AND HELMET
MAINTENANcE
Replace the Front Lens Cover if it is
damaged (cracked, scratched, soiled or
pitted).
Figure 6
1. To Replace the Cover:
Remove the Front Lens Cover by gently a.
pulling up the central part of the Lens.
See Figure 6 . If the unit has a frame
over the front of the lens, lift up on the
tab at the bottom of the frame to access
the lens cover.
Remove the protection film from both
b.
sides of the new Lens if it comes with a
film covering. Place the new Lens into
place by bending it slightly and sliding
it between the tabs at each side of the
lens until it snaps into place.
Make sure that the Lens is securely
c.
installed. If the unit has a frame, make
sure that the frame is snapped securely
into place.
Clean the Filter Lens with a clean lint- 2.
free tissue or cotton cloth.
Do not immerse the lens in water or
3.
any other liquid. Do not use abrasives,
solvents or oil based cleaners.
Do not remove the auto-darkening 4.
filter from the Auto-Darkening Welding
Helmet. Do not try to open the filter.
Storage temperature: -4° to 158° F.
5.