Haan SV-60 - Manual (Page 12)

Fig 3
using Your Steam Vacuum Cleaner:
STeaM Only Function:
4) Before using the Steam Function you need to fill
the water tank. Press the Release button (Fig 3)
to remove the tank. Pull up and out. (Fig 4a & 4b)
5) Open the water tank cap (Fig 5a) and fill the water
tank directly with water up to the maximum
indicator line visible on the clear plastic tank
window. (Fig 5b) Then make sure to secure the cap
back on the water tank. Twist the water tank cap
slightly left and right to push closed. If the water
tank cap cannot be closed securely, lightly wet the
rubber portion of the cap and close. The use of
distilled water is recommended, especially in areas
of hard water. Replace the tank by snapping it back
into place on the body of the SV-60.
6) In order to use the STEAM function you need
to put the Pad Tray on the bottom of your unit
to hold the Ultra-MicroFiber™ Pad in place.
7) There are 4 raised buttons on the underside of
the base of the SV-60 that correspond to indents
in the top side of the Pad Tray. (Fig 7a & 7b)
8) Set the Pad Tray on the floor with the indents
facing up. Align the buttons and press together
until you hear the tray snap into place. (Fig 8)
The Pad Tray has the required ‘nubs’ to hold the
Ultra-MicroFiber™ Pad in place once the unit is
ready to steam.
9) Set the SV-60 upright on the Resting Mat.
10) Plug your unit into a grounded receptacle. The
POWER light will light up RED to indicate that
the power is ON. (Fig 9)
11) Press the STEAM button on the center control
to start the steam function. The STEAM light
will light up ORANGE and the unit will begin to
heat. (Fig 10) Leave the unit on the Resting Pad for
the time it takes (under 1 minute)for the unit
to be ready to steam. The unit is ready when you
Operating Instructions:
(cont)
Fig 7
Fig 5a
pg 10 877-HAAN DIRECT / 877-422-6347 www. HAANUSA.com
b
Fig 8 Fig 9
ON
Fig 10
Push
ON
Fig 4a
Tank
Release
Fig 4b
Fig 5b
MAX
Fill
a