Haan SV-60 - Manual (Page 19)

Care & Maintenance
www. HAANUSA.com 877-HAAN DIRECT / 877-422-6347 pg 17
Haan
®
Helpful Hints:
• The SV-60 may be used to remove fresh stains from
carpet. While you normally do not need to use the
Pad Tray and Ultra-MicroFiber™ Pad while vacuuming
or steaming carpet, you may use both the Pad Tray
and Ultra-MicroFiber™ Pad to remove fresh stains
from carpet. The pad acts as a “blotter” of sorts, to
remove most fresh, wet spills and stains.
First, fill the SV-60 water tank. Snap the tank back
into place. Place the Pad Tray and an Ultra-Microfiber™
pad on the bottom of the SV-60 unit. Plug the unit
in and press the STEAM button. It takes about 40
seconds for the unit to heat up.
Place the unit over the stain and hold it in place
for a few seconds to allow the steam to penetrate
the area of the stain.
Push and pull the SV-60 slowly across the area to
work the steam into the stain. The pad’s absorbency
will work to ‘blot’ the stain from the carpet.
When you have finished using the unit, turn it OFF
and place it on the Resting Mat. Allow the unit to
cool down for approximately five (5) minutes before
removing the Ultra-Microfiber pad from the base.
• You do not have to use a broom and dust pan to clean
up loose dirt from your hard surface floors before
using the SV-60 Steam Vacuum. The unit acts
independently as a vacuum or a steamer or both. For
optimal performance, we recommend using the vacuum
and steamer functions of the SV-60 simultaneously.
• To ensure the best results when using your SV-60,
push the Steam Vacuum forward and backward in
slow, even strokes.