Installation – Heath Zenith Motion Sensor Entryway Light SL-5610/15 User Manual

Page 2

Advertising
background image

2

598-1101-03

INSTALLATION

For best performance, mount the fixture about 7ft (2.1
m) above the ground.

❒

Turn the power to the lighting circuit off at the
fuse or circuit breaker box.

❒

Remove the existing light fixture.

❒

Install the mounting strap

into the junction box. Ori-
entation of the strap may
be different.

❒

Strip about 5/8 in. (15 mm)

insulation off of the existing
junction box wiring.

❒

Connect the

white (neutral) junction box wire to the

white Entryway Light wire. Twist the wires together
and secure with a wire connector.

❒

Connect the

green or

bare (ground) mounting
strap wire to a grounded
wire or to a grounded
metal box.

❒

Connect the

black

(hot) junction box
wire to the

black En-

tryway Light wire.

❒

Install the mounting stem into the strap so

that it extends out about 3/4 in. (19 mm).

❒

Install the fixture over

the mounting stem.

❒

Install and tighten the

mounting stem nut.

Holding Screw

for Globe or Jar

❒

Caulk the back edge of the light and mounting
surface
with silicone weather sealant.

❒

Install a 60 Watt maximum light bulb into the lamp

holder. Do not overtighten.

Higher wattages will

void warranty.

❒

Loosen the front holding screw so the globe or jar

cover can be installed. Secure by tightening the
screw.

Do not overtighten.

Advertising