Philips HX 7351 - Manual (Page 9)

Programmable Quadpacer (specific types only)
The Programmable Quadpacer allows you to customise the Quadpacer in
1 of 3 ways:
You may choose to keep the default setting of a -minute brushing
time with the Quadpacer activated.
You may choose to extend the brushing time by 30 seconds to
.5 minutes with the Quadpacer activated.
You may choose a -minute brushing time with the Quadpacer
deactivated.
To change the Quadpacer setting:
1 Place the handle in the plugged-in charger.
 Press the Dual Speed Control button briefly and note which LED
lights up.
3 Press and hold the Dual Speed Control button. Continue to hold the
button while the LEDs slowly cycle through the Quadpacer settings:
The fourth LED burns green: the -minute Quadpacer is active
(default setting).
The top LED burns green: .5-minute Quadpacer is active.
The bottom LED burns yellow: the Quadpacer is not active.
4 To select the desired setting, release the button when the LED that
corresponds to your choice lights up.
Note:If you select the 2.5-minute Quadpacer, fewer brushings are available
from a fully charged battery.
Dual Speed Control
The Dual Speed Control feature allows you to choose between 2 speed
settings: normal speed (‘Max’) for optimum brushing performance or
reduced speed (‘Gentle’) when you desire an even more gentle brushing
action.
Each time you switch on the Sonicare, it starts to brush at the normal
speed setting.
,
,
,
,
,
,
EngliSh 9
4235.020.1985.2.indd 9 05-05-2006 07:49:14