Harbor Freight Tools CENTRAL PNEUMATIC 94572 - Manual (Page 14)

Page 14 For technical questions, please call 1-800-444-3353. Item 94572
NOTICE
Clean the Spray Gun IMMEDIATELY after use.
Delayed or inadequate cleaning will permanently clog the Spray Gun.
SAFETY
Op
ERA
TION
M
AINTENANCE
SETU
p
Cleaning
Solvent Selection
Follow the paint manufacturer’s
recommendations for cleaning, solvent type,
and disposing of used solvent.
• Latex paints: Do not use
this Spray Gun with latex paint.
IMpORTANT: Do not use mineral spirits
on latex paints or the mixture will congeal,
making it very difficult to remove.
• Oil Based paints: Use mineral spirits.
WARNING! TO pREVENT FIRE,
IF A FLAMMABLE SOLVENT
NEEDS TO BE USED,
ADHERE TO THE FOLLOWING:
a. Follow solvent manufacturer’s clean up
instructions and safety precautions.
b. Flush Spray Gun a full hose
length from air compressor.
c. If collecting flushed solvents in
metal container, transfer to nonmetal
container, and flush metal container.
d. Work far away from any ignition
sources in a vapor free area.
e. Keep class ABC fire extinguisher nearby.
After each use:
1. Empty the Cup and clean it with the solvent.
2. Fill the Cup with solvent and spray it through
the Spray Gun into a container, while shaking
the Spray Gun. Once the Cup is empty, repeat
the process until the solvent comes out clean.
3. Disconnect from the air source.
4. After disconnecting, point the Spray Gun into
the spent solvent container and squeeze the
Trigger again to make sure no air remains.
5. Remove Nozzle and soak it in solvent
until it is clean. Use old toothbrush
and toothpicks to remove any paint.
CAUTION: Do not immerse Spray Gun.
Note: Do not use metal objects to clean the
Nozzle to prevent damage to the passages.
6. Inspect fluid needle and make sure
it is not bent. If it is bent, have it
replaced by a qualified technician.
7. Use appropriate solvent
(see Solvent Selection, left)
to wipe down Spray Gun body.
8. Lubricate Spray Gun after cleaning.
A non-silicon oil or a light lubricant may be
used on threaded connections before storing.
Solution Disposal
After cleaning, dispose of cleaning solution
according to the solution manufacturer’s
directions and local hazardous waste standards.
Air Supply Maintenance
Every day, perform maintenance on the air supply according
to the component manufacturers’ instructions.
Storage
Store in a dry, secure area out of reach of children.