Hustler Turf M1 - Manual (Page 14)

4-4 108548_0711
WARNING: Mower blades are sharp and can cut.
Wrap the blade(s) or wear gloves and use extra caution
when servicing them.
1. Attach the lower handle  to the mower with flanged
nuts. Fig. 4-2
2. Assemble the upper handle to the lower handle .
Use the holder on the right hand side and the two
bolts  on the left hand side and the flanged cap nuts
.Fig. 4-3 and Fig. 4-4
3. Remove the lower bolt and attach the bar to the
mower as shown. Fig. 4-5. Start the bolt in the hole
but do not tighten. Install the bracketto the lower
handle and attach the bar
using hardware and
(flanged cap nutnot shown). Tighten all of the hard-
ware. Fig. 4-5 and Fig. 4-6
NOTE: When adjusting the height of the handle, loosen the
bolt on the bar
, before loosening the handle height adjust-
ment bolt. Fix the cable harness to the handle with velcro
straps so that they do not interfere with the opening / closing
of the guard or operation of the machine. The cable harness
should be routed under the lower handle. Fig. 4-7 and
Fig. 4-8
Fig. 4-2
Fig. 4-3
Fig. 4-4
6
3
13
3
7
13
Upper handle
9
7
3
Upper handle
Fig. 4-5
Fig. 4-6
Fig. 4-7
11
11
11
Lower bolt
11
8
10
Lower handle
11
Loosen bolts to
adjust height