Henkel KHTF-600 - Manual (Page 4)

• Use special care when moving heavily loaded units.
• Do not store combustible material on or around the unit.
• Do not operate this unit empty.
• When using the unit at a distance where an extension cord becomes necessary, a 3-conductor
grounding cord of adequate size must be used for safety, and to prevent loss of power and
overheating. Use only a UL listed extension cord suitable for outdoor use. Make certain wire size is
large enough for A/C amperage rating of unit.
Operation
Locate oven in an area free of combustible material and close to an appropriate power source.
(Check name-plate for voltage.)
**Operator should read the enclosed “2110 Temperature Controller User’s Manual” before
placing oven in operation. Note” The controller has been pre-configured prior to shipping. However fine
tuning may be done in field. **
Wire oven to a fused disconnect of proper voltage and amperage. Load oven with flux and switch
on power. Adjust temperature control set point to desired temperature. Note: Alarm option has been
wired to act as an over-temperature control. See user manual configuration menus.
***CAUTION: DO NOT USE ON D/C POWER SUPPLY!***
Venting
The KHTF-600 is designed to vent around the perimeter of the lid while still maintaining
temperature.
Guide to Storage
See the enclosed guide to storage. This guide may be used in the absence of storage information
from the flux manufacturer. In critical situations, contact your flux manufacturer.
Scheduled Maintenance
The manufacturer recommends that after each use the operator clean all flux residue from
elements and element brackets. Flux build-up on elements may cause hot spots and shorten element life.
Note: For 480 V models, see the attached supplement.
Troubleshooting:
The Keen oven model KHTF-600 requires a minimal amount of
electrical knowledge to repair if necessary.
IF OVEN FAILS TO OPERATE – NO HEAT
1. Check power source.
2. Check power cord continuity. Replace cord assembly if faulty.