Heat & Glo Fireplace Heat & Glo Cosmo-130 - Manual (Page 29)

29 Heat & Glo • Cosmo-I30, Cosmo-I35 • 2239-900 Rev. H • 1/11
A. Remove Glass Assembly
See Section 12.F.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included
with accessories. Contact your dealer for a list of ap-
proved accessories.
WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
12
Appliance Setup
E. Glass Panel Instructions
1. Install back glass panel (see Figure 12.1). Bend retain-
ing tab down to hold back glass panel in position (see
Figure 11.2).
2. Install left glass panel (see Figure 12.1). Install retain-
ing bracket with the self-drilling screw provided to hold
the left glass panel in position (see Figure 12.2).
3. Install right glass panel (see Figure 12.1). Install re-
taining bracket with the self-drilling screw provided to
hold the right glass panel in position (see Figure 12.2).
Figure 12.1 Placement of Glass Panels
B C A
SMOOTH SURFACE MUST FACE OUT
Figure 12.2 Bend Retaining Tab Down
RETAINING TAB
RETAINING
BRACKET
SELF-DRILLING
SCREW
GLASS
PANEL