Assembly / pre-operation – Husqvarna 6521RS User Manual

Page 6

Advertising
background image

6

ASSEMBLY / PRE-OPERATION

TO ASSEMBLE GRASS CATCH ER
1. Put grass catcher frame into grass bag

with rigid part of bag on the bottom.
Make sure the frame handle is outside
of the bag top.

2. Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold
them in warm water for a few minutes. If
bag gets wet, let it dry before using.

TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be
used as a mulcher. To convert mower to
bagging or discharging, see “TO CON-
VERT MOWER” in the Operation section
of this manual.

Frame

handle

Frame

opening

Vinyl
bindings

MOWING

POSITION

Lower handle

LIFT
UP

Operator
presence
control bar

Upper

handle

LIFT

UP

Handle

knob

Read these instructions and this man u al in its entirety before you attempt to assemble
or operate your new lawn mower.
IMPORTANT: This lawn mower is shipped WITHOUT OIL OR GASOLINE in the engine.
Your new lawn mower has been as sem bled at the factory with the ex cep tion of those
parts left unassembled for shipping purposes. All parts such as nuts, washers, bolts, etc.,
necessary to com plete the as sem bly have been placed in the parts bag. To ensure safe
and proper operation of your lawn mow er, all parts and hard ware you assemble must be
tightened se cure ly. Use the correct tools as necessary to ensure proper tightness.

Handle
bracket

Handle pin

SQUEEZE

TO RE MOVE MOW ER FROM CAR TON

1. Remove loose parts included with

mower.

2. Cut down two end corners of carton

and lay end panel down fl at.

3. Remove all packing materials ex cept

padding be tween upper and lower
handle and padding holding operator
presence control bar to upper handle.

4. Roll lawn mower out of carton and

check carton thorougly for ad di tion al
loose parts.

HOW TO SET UP YOUR MOW ER

TO UNFOLD HANDLE
IMPORTANT
: Unfold handle carefully so
as not to pinch or damage con trol cables.
1. Raise lower handle section to operat-

ing position and squeeze the bottom
ends of lower handle towards each
other until the pin in handle can be
inserted into one of the three height
adjustment holes.

2. Remove protective padding, raise up-

per handle sec tion into place on lower
handle and tighten both handle knobs.

3. Remove any packing material from

around control bar.

Your lawn mower handle can be adjusted
for your mowing comfort. Refer to “AD-
JUST HANDLE” in the Service and Adjust-
ments section of this manual.

Advertising