Hitachi L22DP03U - Manual (Page 32)

- 31 -
channel company, then insert those to the TV
using the following procedure.
• Switch off the TV and unplug from the mains.
• Insert the CAM, then viewing card to the slot
that is located in the terminal cover at the
left-hand side of the TV (from front view).
• The CAM should be correctly inserted, it is
impossible to insert fully if reversed. The
CAM or the TV terminal may be damaged if
the CAM is forcefully inserted.
• Connect the TV to the mains supply, switch
on and then wait for few moments until the
card is activated.
• Some CAMs may require the following set
up. Please set the CAM by entering the IDTV
menu, Common Interface then pressing the
OK button. (CAM set up menu is not
displayed when it is not required.)
• To see the viewing contract information: enter
IDTV; press the M button, then highlight
Common Interface and press the OK button.
• When no module is inserted, “No Common
Interface module detected” message
appears on the screen.
• Refer to the module instruction manual for
details of the settings.
NOTE: Insert or remove the CI module only
when the TV is in STAND-BY mode or
SWITCHED OFF.
Navigating the Analogue TV
Menu System
For displaying
menu options
For navigation
To confirm
choices
• Press M to display the main menu.
• Press or button to select an icon. Press
or OK button for more options.
• Use or button to highlight.
• Press or buttons to change the settings.
Press OK to set as default.
• To exit the menu or return from sub-menu
screen, press M.
Note: These explanations are valid for the
navigation of the whole menu system.
To select options that are explained in
the following parts, refer to “Navigating
the Analogue TV Menu System”.
ENG-01-TV-22856W-1165UK-MB29-UKIDTV-(1SCRT-AV-YPBPR-HP-SPDIF-STRLOUT-PCIN)-10059170-50138225.p65 18.11.2008, 09:16 31