Heath Zenith Wireless Chime TR-0095-RX - Manual (Page 2)

-2- 598-1171-03
TR-0095-RX
TYPE C
6. Mount chime. Mount door chime in a central location so it can be heard through-
out the home.
• See actual unit for orientation of base.
• Always use mounting wall anchors.
• Use all mounting holes located at four corners of base.
Code And Tune SeTTIngS
Code Settings
Note: Most installations will not require you to change any jumpers on your
chime and push button.
The push button and chime communicate by using a code that can be changed by
removing and/or adding jumpers on both the push button and chime. The code is factory
set; however, there are 128 selectable codes that allow you to expand your system and
prevent outside interference. Other wireless products may cause interference and the
system may not function properly. Follow the instructions below for setting a new code.
1. Open the cases and locate the jumpers on both the push button and chime (See
illustration on page 3).
2. The push button and chime both have eight different jumper locations. The jumper
positions 1 through 7 are used for setting the code.
3. To change the code, add and/or remove jumpers as needed. It is recommended to
only change one jumper at a time and then check to see if system is functioning
properly.
Note: Jumpers in positions 1 through 7 must be exactly the same for both the
push button and chime for this system to function.
Screw
Mounting
Orientation
Marking
Cover Pins
Mounting Hole
Wall Anchor
(If Needed)