Heath Zenith Wireless Chime TR-0095-RX - Manual (Page 3)

-3- 598-1171-03
Tune Settings
Your wireless chime has different selectable tunes: ding (one note), ding-dong (two
note), or Westminster (eight note) (Available on selected chimes). The factory setting
is for the Ding-Dong tune (or Westminster, when available). This tune can be changed
by following the instructions below.
•
ding (one note tune)
Push Button: Add a jumper to location 8.
•
ding-dong (two note tune)
Push Button: Remove jumper from location 8.
Chime: Remove jumper from location 8.
•
Westminster (Eight note tune) (Available on selected chimes)
Push Button: Remove jumper from location 8.
Chime: Add a jumper to location 8.
Note: All models have both front and back door tune capabilities. We recommend the
back door use the
ding tune and the front door use the ding-dong tune (or West-
minster tune, available on selected chimes). Models that include two push buttons
will come factory set for front and back doors. Decals on the rear of the push button
will indicate its setting.
TYPE
C
TYPE
C
1
2
3
4
5
6
7
8
1 2
3
4
5
6
7
8
Push Button Battery Replacement
Install an alkaline type A23 12 Volt battery. See diagram
inside push button for correct orientation of batteries.
* Code Settings 1-7
Must Match Both Push
Button and Chime
Inside Push Button
Inside Chime
Tune Setting
(Not used on
all models)
Tune Setting
Note: Some models might require the use of
tweezers to remove and replace the jumpers.