Horizon Fitness SXS 5.7 - Manual (Page 4)


INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
CONDITIONING
GUIDELINES
TROUBLESHOOTING
&
MAINTENANCE
LIMITED
W
ARRANTY
7
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE YOU
BEGIN
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
TOOLS INCLUDED
PARTS INCLUDED
1 Seat Set Safety Pin
2 Foam Rollers
1 Seat Back Pad
1 Seat Bottom Pad
1 Main Base Frame
1 Main Support Frame (Right)
1 Main Support Frame (Left)
1 Radial Arm Assembly
1 Nylon Ankle Strap 1 Center Support Frame
2 Handles
1 Leg Extension/Curl Down Tube
1 Seat Weldmen Set
2 Weight Shields
2 Guide Rods
1 Weight Selection Pin
1 Upper Pulley Assembly
1 Lat Pulldown Bar 1 Dual Floating Pulley Bracket
1 Front Cover
1 Back Cover
2 Single Floating Pulley Brackets
1 Upper Pulley Assembly
1 Lat Bar Bracket Assembly
4 Cables
9 Hardware Bags
LAT PULLDOWN BAR
COVER SET
HANDLE
LAT BAR BRACKET ASSEMBLY
MAIN SUPPORT FRAME (RIGHT)
CENTER SUPPORT FRAME
CABLE “C”
RADIAL ARM ADJUSTMENT PIN
SEAT BACK PAD
SEAT BOTTOM PAD
SEAT WELDMENT SET
SEAT HEIGHT ADJUSTMENT KNOB
LEG EXTENSION/
CURL DOWN TUBE
FOAM ROLLERS
ADJUSTABLE FOOTPLATE CABLE “B”
BASE FRAME
SEAT SET SAFETY PIN
MAIN SUPPORT FRAME (LEFT)
SINGLE FLOATING PULLEY BRACKET
WEIGHT SELECTION PIN
WEIGHT SHIELD
DUAL FLOATING PULLEY BRACKET
SINGLE FLOATING PULLEY BRACKET
GUIDE ROD
UPPER PULLEY ASSEMBLY
CABLE “A”
RADIAL ARM ASSEMBLY
CABLE “D”
If you have questions or if there are any missing parts, contact 1-800-4-MY-HOME ® .
Further contact information is located on the back cover of this manual.
For a complete exploded diagram, see Quick Start and Parts Guide (included in User’s Guide bag).
Screwdriver
19 mm Flat Wrench
13 mm/17 mm Flat Wrench 4 mm Allen Wrench
6 mm Allen Wrench
8 mm Allen Wrench
NOTE: During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before
completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware.
Any grease, such as lithium bike grease is recommended.
PRE-ASSEMBLY
ASSEMBLY STEP 1
BASE FRAME
MAIN SUPPORT
FRAME (RIGHT)
MAIN SUPPORT
FRAME (LEFT)
NYLON NUT (C)
FLAT WASHER (B)
CENTER SUPPORT
FRAME
Place BASE FRAME on floor in
desired location.
Remove 6 NYLON NUTS (C)
and 6 FLAT WASHERS (B) from
BASE FRAME.
Attach RIGHT MAIN SUPPORT
FRAME to right side of BASE
FRAME using 2 FLAT WASHERS
(B) and 2 NYLON NUTS (C).
Repeat on other side.
Attach CENTER SUPPORT
FRAME to BASE FRAME using
2 FLAT WASHERS (B) and 2
NYLON NUTS (C).
A
B
C
D
E
SXS_5.7_rev.1.1.indd 6-7 8/30/07 11:12:39 AM