HP Vectra VE 5/series 2 - Manual (Page 65)

Data Cable
Power Cable
9 Slide the power supply back into position, and tighten its self-retaining screws (see
"Replacing the Power Supply after Installing Accessories" earlier in this chapter).
10 Remove the plastic panel from the cover by pulling the panel from the left and unhinging
its right-hand side. Store the panel in a safe place.
Unclip and lift out the plastic panel
11 Install any other accessories before replacing the cover and completing the installation.
Completing the Installation of an IDE CD-ROM drive
1 Turn on the computer and press [F2] when <Setup=F2> appears.
2 In the IDE Secondary Channel section of the Setup program, make sure that the CD-
ROM drive has been detected.
3 Press [F3] to save and exit the program.
Completing the Installation of a Flexible disk drive
1 Turn on the computer and press [F2] when <Setup=F2 > appears.
2 Check that the Setup program has detected the drive in the Flexible Disk Drives section.