HP Vectra VE 5/series 2 User Manual

Page 74

Advertising
background image

BIOS Error Messages that May Prevent Your PC From Starting:

Cannot start from
hard disk (A new
drive may need to be
partitioned and
formatted).

For more information
refer to your
manual. To continue
without an explana-
tion, just press F1.

Explanation:

There is no operating system installed on your hard disk.

What you should do:

Install an operating system on the hard disk or insert a diskette
with an operating system, and press any alphanumeric key to
continue.

Refer to chapter 1 of this User’s Guide for instructions on installing
an operating system.

Insert system
diskette in drive.

Press any key to
continue.

Explanation:

•

there is no operating system installed on your hard disk

•

there is no operating system on the diskette in drive A

•

the hard disk drive is disabled, or not present.

What you should do:

Install an operating system on the hard disk or insert a diskette
with an operating system, and press any alphanumeric key to
continue.

Refer to chapter 1 of this User’s Guide for instructions on installing
an operating system.

Boot program in
first sector of
diskette is invalid,
cannot start from
this diskette.

Cannot start from
hard disk.

Explanation:

There is a problem with the disk drive, or the disk drive is not
properly formatted.

What you should do:

Insert a diskette with the proper operating system, and press any
alphanumeric key to continue.

Missing operating
system

Explanation:

You tried to start the PC but the PC could not find the operating
system.

What you should do:

Run Setup and make sure the hard disk has been correctly
configured.

System boot process
failed. Press any
key to try again.

Explanation:

You tried to start the PC but the PC could not find the operating
system.

What you should do:

•

check the diskette contains the operating system

•

check the hard disk contains the operating system

•

ensure “start from the flexible disk” or “start from the hard

disk” is enabled in Setup
•

for a network, ensure “remote start” is enabled in Setup.

Advertising