HP N31.5 - Manual (Page 47)

47
A – sign beside an option indicates that it is currently off; a + sign
indicates that it is currently on.
If you continue clicking display mode after the display shows
DISPLAYLINK+ , the links are shown again beginning with INDEX 0 ,
then RECORD LINK , then MUTE LINK, and so on.
5. Stop clicking display mode when the display shows a link you
would like to change.
5. To turn the link on, press the program + button; to turn the link
off , press the program – button.
6. Repeat steps 4 and 5 for each link setting you want to change.
When you’ve finished, wait several seconds for the display to return to its stan-
dard mode.
Your link settings remain in memory when you place the Nº31.5 into standby ,
when you turn off the main power switch — even if AC power is interrupted.
Auto-Standby The Nº31.5 also may be set to automatically enter standby when left in stop for a
user-selectable period of time. As shipped from the factory, its standby function is
manual (that is, it only enters or leaves standby when told to do so by the user).
To change between manual and timed/automatic standby:
1. Press and hold the standby button until the display reads MANUAL .
2. Release the standby button and then “click” search forward to ad-
vance the timer. Single clicks will advance it by one minute. Press-
ing and holding the button will stream the numbers by to a maxi-
mum of 120 minutes.
Search reverse reduces the timer delay, with
MANUAL coming below the 1 minute mark.
3. When you have selected the delay you desire, simply allow the
Nº31.5 to “time-out” and revert to a normal display.
The Nº31.5 will display AUTO STANDBY for about one second prior to actually go-
ing into standby as a result of the auto standby setting you have chosen.