Hitachi VM-E230A - Manual (Page 18)

Getting Started
Getting Started
This section guides you through the initial preparation of the camcorder. None of these
processes are complex. Set aside some time, relax, and familiarize yourself with this
quality instrument.
Enjoy getting to know all about your Hitachi 8mm camcorder. The more comfortable and
familiar you are with the machine and its features, the more you can make it do for you.
Let's get started!
It is crucial that you read and understand all the safety instructions before you begin. If
you haven't read the safety instructions yet, please take the time to do so now.
Charging the Battery
The first step is to set the battery to charge. It takes approximately an hour (VM-
BP82G), enough time to familiarize yourself with some of the basic features of the
camcorder. Once fully charged the battery will give an operating time of approximately
60 minutes, but this is reduced to a half to one-third depending on how often you use
zoom and start/stop functions.
Charge the battery at a temperature range of 50°F(10°C) - 86°F(30°C) to prevent
damage to the battery.
1. Plug the AC adapter/charger power cord into an AC outlet. Make sure that the wide
blade fits into the wide slot. If it doesn't fit try reversing it. If you still cannot make fit the
blades fully into the outlet either contact an electrician to replace your obsolete outlet, or
use a polarized cord or outlet accessory.
2. To insert the battery into the charger align the reference arrow on the battery with the
reference arrow on the AC adapter/charger. Push the battery till it is flush with the AC
adapter/charger sliding it in the direction of the arrow as shown in the figure.
3. The CHARGE light remains on while the battery charges, turning off when charging
completes.
Note: Remove the DC cord from the AC adapter/charger before attempting to charge the
battery. The CHARGE light flashes if the DC cord remains connected while you attempt to
charge the battery.
Note: Do not operate the battery at temperature below 14°F (-10°C) or above 95°F (35°C).
At extremely low temperatures operation time decreases, while at high temperature the
battery may be damaged.
After charging set the mark switch to red so that you may quickly identify
whether the battery is charged or uncharged.
Note: The marker switch does not guarantee the batteries charge status.