Hitachi VM-E230A - Manual (Page 46)

Advanced Techniques
Note: Use the wireless remote control within the range of the infrared receiver of the
camcorder shown above.
Note: The wireless remote control may not function in strong light such as direct sunlight or
very bright artificial lighting.
Note: Clear a direct path from the wireless remote control to the infrared receiver. The
wireless remote control won't work if an obstacle blocks the infrared rays.
Note: The remote control code of this camcorder is Hitachi code VCR2. If you have a VCR
with the same code your Hitachi VCR may malfunction when you use the camcorder's
wireless remote control.
Using Memory
The linear time counter memory stops a rewinding tape at approximately 0:00:00M. This
feature helps in locating a specific point in the tape to which you wish to return. An
example might be that you have recorded some tape that you have already watched,
you continue recording but do not care to watch the tape you recorded earlier. The
memory feature returns you to the beginning of the most recent recording.
1. Press the DISPLAY button on the remote control so the linear time counter with
memory is displayed as shown in the figure.
2. Start recording or playback of a cassette. Press the COUNTER RESET button on the
remote control at the point to which you wish to return. The linear time counter clears to
0:00:00M.
3. Press the STOP button to stop playback, or press the start/stop recording and set the
CAM/OFF/VIDEO switch to VIDEO.
4. Press the REW button and the tape stops at approximately where you reset the linear
time counter. This feature works in F.F as well.