Hitachi DH40MB - Manual (Page 27)

26
English
SPECIFICATIONS
Voltage (by areas)* (110V, 115V, 120V, 127V, 220V, 230V, 240V)
Power input 950 W*
Capacity Drill bit: 40 mm
Core bit: 105 mm
No load speed 180 – 360/min.
Full-load blow 1400 – 2800/min.
Weight (without cord, side handle) 6.6 kg
* Be sure to check the nameplate on product as it is subject to change by areas.
Adapter for SDS-plus shank bit
3. Large dia. hole boring (Rotation + Hammering)
(1) Center pin
ⅷ Applied to core bits from 38 mm to 105 mm
ⅷ Applied to core bits 32 mm and 35 mm
NOTE
Do not use core bits 25 mm or 29 mm.
(2) Core bit
ⅷ External dia. 25, 29, 32, 35, 38, 45, 54, 64, 79, 94,
105 mm
(with guide plate, not applicable to cores 25 mm
or 29 mm)
(3) Core bit shank
ⅷ Applied to core bits above 38 mm
ⅷ Applied to core bits below 35 mm
4. Drilling holes ..... For drilling metals and wooden
materials
(1) Drill bit
(SDS-plus shank)
(2) Core
bit
(Guide
plate) (1) Center
pin
13 mm drill chuck
(13VLA) Chuck adapter
(SDS max shank)
Chuck wrench
STANDARD ACCESSORIES
(1) Case (Molded plastic) .............................................. 1
(2) Side Handle ............................................................... 1
(3) Stopper ....................................................................... 1
(4) Hexagon Bar Wrench (for 6 mm screw) ............ 1
(5) Hexagon Bar Wrench (for 5 mm screw) ............ 1
(6) Hammer Grease A ................................................... 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
1. Through-hole drilling (Rotation + Hammering)
(1) Drill bit (SDS max shank)
2. Anchor hole drilling (Rotation + Hammering)
Overall length (mm)
340 540
320 520
370 570
Outer diameter (mm)
16
19
22
25
28
32
38
40
Drill bit (Taper shank)
(3) Cotter
(1) Drill bit (taper shank)
External dia.: 11, 12.3, 12.7,
14.3, 14.5,
17.5 mm
(2) Taper shank
adapter
(SDS max shank)
Taper shank
adapter
Morse taper
(No. 1)
Application drill bit
Drill bit (taper shank)
11, 12.3, 12.7, 14.3, 14.5, 17.5 mm
(2) Adapter for SDS-plus
shank bit
(SDS max shank)
(3) Core bit
shank
(SDS max shank)