Hobart Welding Products HANDLER 140 OM-925 - Manual (Page 31)

.
A complete Parts List is available at www.HobartWelders.com
OM-925 Page 27
7-4. Changing Drive Roll Or Wire Inlet Guide
1 Inlet Wire Guide Securing
Screw
2 Inlet Wire Guide
Loosen screw. Slide tip as close to
drive rolls as possible without
touching. Tighten screw.
3
Drive Roll
The drive roll consists of two differ-
ent sized grooves. The stamped
markings on the end surface of the
drive roll refers to the groove on the
opposite side of the drive roll. The
groove closest to the motor shaft is
the proper groove to thread (see
Section 5-9).
4
Retaining Pin
To secure drive roll, locate open slot
and push drive roll completely over
retaining pin, then rotate drive roll
(1/4 turn) to closed slot.
Tools Needed:
Ref. 803 714-A
.023/.025 Groove .030/.035 Groove
Stamped .024 Stamped .030/.035
4
1
2
3
7-5. Replacing Gun Contact Tip
Ref. 802 399-A
! Turn Off power before
replacing contact tip.
1 Nozzle
2 Contact Tip
Cut off welding wire at contact tip.
Remove nozzle.
Remove contact tip and install new
contact tip. Reinstall nozzle.
Tools Needed:
1
2