HTC Mogul - Manual (Page 183)

AC Phone Charger
Use the Correct External Power Source
A product should be operated only from the type of power source indicated on the electrical ratings label. If
you are not sure of the type of power source required, consult your authorized service provider or local power
company. For a product that operates from battery power or other sources, refer to the operating instructions
that are included with the product.
The AC phone charger designed by UT Starcom for this unit requires the use of a standard 120 V AC power
source for device operation.
Never attempt to disassemble or repair an AC phone charger. Never use an AC phone charger if it has a damaged
or worn power cord or plug. Always contact a UT Starcom authorized service center, if repair or replacement is
required.
Never alter the AC cord or plug on an AC phone charger. If the plug will not fit into the available outlet, have a
proper outlet installed by a qualified electrician.
Never allow any liquids or water to spill on an AC phone charger when it is connected to an AC power source.
Always use the authorized UT Starcom AC phone charger to avoid any risk of bodily injury or damage to your
cellular phone or battery.
Never attempt to connect or disconnect the AC phone charger with wet hands. Always unplug the AC phone
charger from the power source before attempting any cleaning. Always use a soft cloth dampened with water to
clean the equipment, after it has been unplugged.
Handling the cord on this product or cords associated with accessories sold with this product, will expose you to
lead, a chemical known to the State of California to cause birth defects or other reproductive harm. Wash hands
after handling.
Always disconnect the travel charger or desktop charger from the power source when it is not in use.
Appendix 187