Husqvarna HUV 4213-GXP - Manual (Page 18)

Seat Latch and Adjustment
164
Figure 11 Low Oil Warning Light
FUEL GAUGE/HOUR METER
A fuel gauge and hour meter are housed together at the lower left corner of the instrument panel. The fuel gauge
operates when the key switch is in the ON position, and allows the operator to monitor the fuel level in the vehicle. The
hour meter operates only when the engine is running, and should be used only by trained technicians to track vehicle
usage and determine when periodic service procedures are required. See Periodic Service Schedule on page 27.
HEADLIGHT CONTROL
The headlight control is located on the front instrument panel between the fuel gauge/hour meter and steering column.
Pull the headlight control knob out to turn the headlights on and push the knob in to turn the headlights off.
NOTE: Using the headlights for extended periods of time without the engine running, or with the engine idling, will
discharge the battery.
LIGHT BAR CONTROL
The light bar control is a toggle switch located on the instrument panel above and slightly left of the headlight control
knob. Place the toggle switch in the upper position to illuminate the light bar lights and in the lower position to turn the
light bar lights off.
SEAT LATCH AND ADJUSTMENT
The seats are hinged to allow easy access to the engine compartment. A latch at the rear of each seat bottom keeps
the seat from moving on its hinges while the vehicle is in operation. To disengage the latch, grasp the seat back and
pull firmly in a forward/upward direction until the latch releases. To engage the seat latch, push down firmly on the seat
back until the seat locks into place. See following WARNING.
Page 16 2008 HUV 4213-G and HUV 4213-GXP Owner’s Manual