Hitachi C43-FD7000 - Manual (Page 53)

53
CONNECTION WITH OTHER EQUIPMENT
About the jacks and connections of rear panel
1. Refer to the operation manual of your electronic equipment for additional information on connections.
2. If your device has only one audio output (mono sound), please connect it to the left channel jack (MONO/L).
3. Audio and video signal from the same source should be connected to the same group of terminals. Do not mix
them.
4.Terminals ˄Y/VIDEO,P
B
/C
B
,P
R
/C
R
˅in INPUT1 and INPUT2 are used to connect component outputs of HDTV
STB, DVD, PDVD, etc. Y/VIDEO input terminal can also be used as the standard video terminal.
When you use Y/VIDEO, P
B
/C
B
, P
R
/C
R
terminals to connect component signals, press the RECALL button on
the remote control unit to show the characters COMPONENT and AV1 or AV2 at the top right corner of the
screen, which indicates that you are using component terminals to receive signals. However, when you use
Y/VIDEO terminal instead of Y/VIDEO, P
B
/C
B
, P
R
/C
R
terminals to receive video signal, only the character AV1
or AV2 will appear at the top right corner of the screen.
5. If your device has s-video signal output, please use s-video signal instead of the standard video signal.
If there are signals input from the same group of S-VIDEO and VIDEO terminals, the TV will receive signal
from S-VIDEO and the characters S and AV3 or AV4 will appear at the top right corner of the screen by
pressing the RECALL button, which indicates that you are using S-VIDEO terminal to receive signals.
6. ˄VIDEO˅MONITOR OUT terminal outputs video signal receiving from RF, S-VIDEO or VIDEO terminal to
external equipment for observation and use. When receiving component signals (Y ˈP
B
/C
B
ˈP
R
/C
R
) in INPUT1
or INPUT2, there is no output from ˄VIDEO˅MONITOR OUT terminal.
7. ˄S-VIDEO˅MONITOR OUT terminal outputs S-VIDEO signal receiving from S-VIDEIO inputs to external
equipment for observation and use. When receiving signals from RF, VIDEO or Y, P
B
/C
B
, P
R
/C
R
terminals, there
is no output from ˄S-VIDEO˅MONITOR OUT terminal.
8. ˄FIXED/VARIABLE AUDIO˅MONITOR OUT terminals provide fixed or variable audio level output to
external stereo system.
9. TV AS CENTER input jacks
These jacks are for stereo amplifiers with center signal output capability. This feature allows the TV speakers to
be used as a center speaker.
10. IR BLASTER output jacks
Refer to page 35-45 for the use of AV NET function through IR BLASTER output jacks.