HP B180L User Manual
Page 120
106
Changing Your Workstation’s Hardware Configuration
This appendix describes the procedures to change your workstation’s hard-
ware configuration. It presents the information in the following sections:
•
Checking the SCSI IDs
•
Preparing your workstation
•
Removing the main tray assembly
•
Replacing the main tray assembly
•
Installing storage devices
•
Installing additional memory
•
Installing cache boards
•
Installing an EISA, GSC, or PCI option board
•
Installing an optional System Graphics RAM (EGRAM) board
•
Changing your monitor type
CAUTION:
Always wear a properly grounded wrist strap when reconfiguring your
workstation.
Use the following tools to remove or replace hardware parts when changing
your configuration:
•
Light-duty flat blade screwdriver with 150 mm (6 in.) blade
•
Needlenose pliers
•
Torx screwdriver
Also, read the ESD Precautions in Appendix A of this guide.