HP B180L - Manual (Page 236)

222
The Boot Console Interface
Configure and Display LAN Settings (B132L+/B180L Only)
Configure and Display LAN Settings (B132L+/B180L
Only)
The LanConfig command configures and displays the current LAN settings.
The hardware system supports 10Base-T, 100Base-T and AUI standards.
To automatically select the network speed (100 Mbits/sec or 10 Mbits/sec) and data
transfer operation (full or half duplex), operating in compliance with IEEE 802.3u,
(this is the default and recommended setting) type the following at the prompt:
Configuration Menu: Enter command > LanConfig AUTO
To select 10 Mbits/sec network speed and half duplex mode, type the following at
the prompt:
Configuration Menu: Enter command > LanConfig 10/Half_dx
To select 10 Mbits/sec network speed and full duplex mode, type the following at
the prompt:
Configuration Menu: Enter command > LanConfig 10/Full_dx
To select 100 Mbits/sec network speed and half duplex mode, type the following at
the prompt:
Configuration Menu: Enter command > LanConfig 100/Half_dx
To select 100 Mbits/sec network speed and full duplex mode, type the following at
the prompt:
Configuration Menu: Enter command > LanConfig 100/Full_dx
To select the AUI port (10 Mbits/sec, half duplex only), type the following at the
prompt: