HONDA metro 21 - Manual (Page 22)

- 17 -
3.3.8 Adjusting the Cutting Height
Each wheel is adjusted individually with a wheel height adjustment lever. The
cutting heights are listed in the following table.
Cutting Heights
0.75 in (19 mm) 2.25 in (57 mm)
1.25 in (32 mm) 2.75 in (70 mm)
1.75 in (44 mm) 3.25 in (83 mm)
DANGER
POTENTIAL HAZARD
♦ Adjusting the cutting height levers could
bring your hands into contact with a
moving blade.
WHAT CAN HAPPEN
♦ A moving blade can cause serious injury.
HOW TO AVOID THE HAZARD
♦ Stop the engine and wait for all movement
to stop before adjusting the cutting height.
♦ Do not put your fingers under the housing
when adjusting the cutting height.
1. Pull the wheel height adjustment lever toward the wheel (Fig. 9) and move it
to the desired setting.
2. Release the wheel height adjustment lever and set it securely in the notch.
3. Adjust all the wheels to the same cutting height setting.
3.3.9 Using the Grass Bag
Occasionally, you may wish to use the grass bag for bagging extra long grass,
lush grass, or leaves.
Installing the Grass Bag
1. Stop the engine and wait for all moving parts to stop.
2. Ensure that the discharge door handle is fully forward and that the pin is
engaged in the catch (Fig. 10).
Figure 9